- Μηνύματα
- 47,842
- Πόντοι
- 2,368
παντως αυτος
http://safari.oreilly.com/1592006256/ch07lev1sec2
τη..."δικη" μου μεθοδο προτεινει (δηλ.το χαμηλωμα των individual tracks ωστε να μην πικαρει το master bus στο οποιο αφηνει το fader στο "0"...
(το προηγουμενο,....θαυμα μιξης και παραγωγης ;D παντως οπως λεει ο μαγκας το εκανα...)
http://safari.oreilly.com/1592006256/ch07lev1sec2
τη..."δικη" μου μεθοδο προτεινει (δηλ.το χαμηλωμα των individual tracks ωστε να μην πικαρει το master bus στο οποιο αφηνει το fader στο "0"...
παντως επειδη αυτες τις μερες μιξαρω (κομπογιαννιτικα παλι ;D) το νεο μας cd θα δοκιμασω και τις 2...μεθοδες ;D & θα σας πω..Level of the Master Fader: When there are clips on the Master Fader, most people drop the Master Fader until the peak goes away. This is not the best maneuver, however, because you might be curing the symptom but not the problem. The problem when you peak the Master Fader is generally that you have too much signal in your mix. Put simply, the mix is overly hot and is filling the Master Bus to overflowing. When you lower the Master Fader, you lower the capacity on the Master Bus, not the amount of signal going to it. Eventually, you might go beyond the 6-dB range (you lose one bit every time your volume falls below –6 dB), shrinking your bit count and reducing the image width, clarity, and dynamic range of the mix.
Unfortunately, a better method is not so easy. You need to lower the faders for all the channels before the Master Fader.
(το προηγουμενο,....θαυμα μιξης και παραγωγης ;D παντως οπως λεει ο μαγκας το εκανα...)